Crestron-electronic CHV-TSTATRF Manual de usuario descargar pdf (Pagina 26)

infiNET™ Thermostat Crestron CHV-TSTATRF

Setup Mode Parameters/Functions (Continued)

PARAMETER/

FUNCTION

CODE VALID VALUES

DEFAULT

VALUE

NOTES

Power Source Po

24V always available

(24) or steal power

(SP)

24

Selects source of input power for

thermostat. 24VAC assumes

constant power is available

between the C and RH

connectors. The steal-power

function allows recovery of some

power from the HVAC system

when constant power is not

available. Steal power may not

work with some zone controllers.

In this case, set value to “24” and

ensure that you have two AA

batteries installed.

Check Firmware

Version

rE

Firmware version is

displayed in xx.yy.zz

format. “—“ can also

be displayed

--

When firmware version is not yet

shown, display will be “—“. Each

press of the or button will

cycle to the next portion of the

version number.

infiNET ID (MNET ID) id 01 and 03 – FE 01

Sets the infiNET ID. SIMPL

Windows restricts infiNET

devices to an ID range of 03 –

20.

infiNET RF Channel CH

11-26 for fixed-channel

operation, “Au” for auto

or “0” for disabled

(battery saver)

26

Selects the RF channel. A fixed

channel allows faster setup and

reconnect when the gateway

channel is fixed. Auto channel

allows more flexibility but may

consume slightly more power if

network communications are

interrupted. A setting of “0”

disables the radio.

infiNET Sleep Time SL Short (S) or Long (L) L

Indicates thermostat update rate.

Setting for fewer updates (“L”) will

conserve battery power.

Start infiNET Acquire AC

Not started (--)

In progress (flashing --

)

Finished, found GW

(00)

Finished, could not find

GW (E#, where #

represents an error

code)

N/A

Used to acquire the device to a

gateway.

”E0” indicates that search time

has expired and no gateway was

found.

”E1” indicates the infiNET RF

Channel is set to “0” (disabled).

Unacquire Gateway UA

Not started (--)

In progress (flashing --

)

Finished, success (00)

Finished, failed (E#,

where # represents an

error code)

N/A

Used to remove gateway

information from the device, so it

will no longer communicate with

the current gateway.

”E0” indicates that there is no

previous gateway information (i.e.

the gateway may already have

been unacquired).

(Continued on following page)

22 • infiNET™ Thermostat: CHV-TSTATRF Operations & Installation Guide – DOC. 6490A

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 47 48

Comentarios a estos manuales

Sin comentarios