Crestron-electronic CHV-TSTATRF Manual de usuario descargar pdf (Pagina 25)

Crestron CHV-TSTATRF infiNET™ Thermostat

Setup Mode Parameters/Functions (Continued)

PARAMETER/

FUNCTION

CODE VALID VALUES

DEFAULT

VALUE

NOTES

Heat Anticipator HA 1 – 6 3

Lower setting results in more

frequent cycles and faster

response (tighter regulation).

Higher setting results in less

frequent cycles and slower

response (looser regulation). The

default value should suffice in

nearly all installations.

Cool Anticipator CA 1 – 6 3

Lower setting results in more

frequent cycles and faster

response (tighter regulation).

Higher setting results in less

frequent cycles and slower

response (looser regulation). The

default value should suffice in

nearly all installations.

Heat pump Balance

Point

(will only appear for

Heat pump and Dual-

Fuel Heat pump

systems)

Hb

16 to 90 (for

Fahrenheit) or

-9 to 32 (for Celsius) or

Disabled (--)

--

Heat pump systems have

performance restrictions based

on outdoor temperature. This

setting is the minimum outdoor

temperature at which the heat

pump (or dual-fuel heat pump)

system will run.

Aux-Heat Balance

Point

(will only appear for

Heat pump type

systems)

Ab

16 to 90 (for

Fahrenheit) or

-9 to 32 (for Celsius) or

Disabled (--)

--

Aux heat operation is locked out

when outdoor temperature

exceeds the Aux Heat Balance

Point. Dual-fuel systems do not

allow both the heat pump and the

aux to run at the same time.

Interstage Differential

(will only appear for

Heat pump systems)

dF

05 to 80 (tenths of a

degree Fahrenheit),

adjustable in 5 tenths

degree increments or

05 to 45 (tenths of a

degree Celsius),

adjustable in 5 tenths

degree increments

20 (F) or

10 (C)

Heat pump systems can allow

both the heat pump and aux to

run at the same time. This sets

the ambient temperature

threshold to trigger aux heat in

addition to the heat pump.

Run Fan During Heat

Calls

HF

Enabled (Y) or

Disabled (no)

no

Most heat systems handle the fan

call if required. If the system

requires the thermostat to control

the fan during heat calls, set this

parameter to “Y”.

Changeover Outputs

(will only appear for

Heat-Cool systems)

Co

Enabled (Y) or

Disabled (no)

no

Indicates the mode in which the

thermostat is operating. Will

automatically be engaged for

heat pump or dual-fuel heat

pump systems. If not required, it

should be disabled to extend

battery life.

(Continued on following page)

Operations & Installation Guide – DOC. 6490A infiNET™ Thermostat: CHV-TSTATRF • 21

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

Comentarios a estos manuales

Sin comentarios